TANDBERG MPS 200 Administrator's Manual page 26

MPS 200/800
Contents Introduction
Starting up the system
Preparations
Before starting the TANDBERG MPS make sure
the following has been done:
The System Controller Board must be
1.
installed in the first slot in the chassis.
Make sure the Media Processing Board(s)
2.
and the Network Interface Card(s) are
interted correctly into the chassis.
2. MPS 800: Make sure the Power Unit(s)
are inserted correctly into the back of the
chassis.
Power Cable
3. Connect the .
Turning on the MPS
Set the Power Switch on the back of the chas-
1
sis to .
Startup mode
!"
On the front of the chassis you will see the
CPU LED
on the System Controller Board
flashing
!"
On the Media Processing Boards the
LED turns green.
!"
Active
The LED is flashing green while
software is being uploaded to the Media
Processing Boards.
!"
In the LCD (Liquid Crystal Display) you will
see the logo.
The system is ready for configuration
Power Active
1. When both and LED's on the
Media Processing Boards are steady green
2. And the initial configuration menu appears
on the LCD.
D14033.10—APRIL 2009
Getting started Getting started Using the MPS
Liquid Crystal
Display
Power LED
Active LED
Liquid Crystal
Display
Power
CPU LED
System status System configuration Gateway configuration
MPS200 Front Side
CPU LED
MPS800 Front Side
Power LED
Active LED
MCU configuration Appendices
MPS200 Back Side
MPS800 Back Side
Power
Switch
Power
Cable
Administrator Guide
Contact us
Power
Switch
Power
Cable
25