D-Link DSL-124 User Manual page 47
Wireless n300 adsl2+ modem router
Hide thumbs
Also See for DSL-124:
- Quick installation manual (8 pages) ,
- User manual (2 pages) ,
- Modem configuration manual (2 pages)
Table of Contents
Advertisement
Section 4 - Configuration
Select 1483 Routed.
Channel Mode:
VPI:
The virtual path identifier (VPI) is the virtual path between two
points in an ATM network. Its valid value is between 0 and 255.
Enter the correct VPI provided by your ISP.
VCI:
The virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 32 and
65535. Enter the correct VCI provided by your ISP.
Encapsulation:
Select the type of encapsulation your ISP uses, either Logical Link
Control (LLC) or Virtual Circuit Multiplexing (VC-Mux).
Enable NAPT:
Check this box to enable NAT, which allows devices on your
network to share one public IP address.
Enable IGMP:
Check to enable IGMP Multicast.
VLAN:
Choose to either Disable or Enable the use of VLANs.
VLAN ID(1-4095):
If you enabled VLAN, enter the VLAN ID.
IP Protocol:
Select the type of IP addressing: IPv4/v6, IPv4, or IPv6. This will
effect the WAN IP Settings and WAN IPv6 Settings.
PPP Settings:
1483 Routed mode does not support PPP authentication.
WAN IP Settings:
Configure the IPv4 WAN settings. If the IP Protocol is set to IPv6,
these settings are unavailable.
Type:
Only Fixed (Static IP) is available for 1483 Routed Mode.
D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
1483 Routed Mode (DSL WAN Only)
WAN CONFIGURATION
42
Advertisement
Table of Contents
