Panasonic NV-DS27 Operating Instructions Manual page 9

1
1
2
3
15˚
1
15˚
15˚
15˚
START/
DATE/ PHOTO
STOP
OSD TIME SHOT
COUNTER RESET TITLE
ZOOM
T
MULTI/
REC A.DUB
P-IN-P
¥
V /REW PLAY FF/ W
W
6 1 5
STILL ADV PAUSE STILL ADV
E ; D
INDEX STOP INDEX
2
K L
∫
SELECT
VAR. P.B.
SEARCH ZOOM
STORE
MENU
SET
OFF/ON
ITEM
P.B.DIGITAL
ª Inserting a Button-type Battery
Before using the Remote Controller, insert the supplied button-type battery.
1
While pressing the Stopper
2
Insert the button-type battery with the imprint (i) facing
upward.
3
Insert the Battery Holder into the Remote Controller.
≥When the button-type battery is weak, replace it with a new CR2025 battery.
(A battery is normally expected to last about 1 year. However, it depends on
operation frequency.)
≥Make sure to match the poles correctly when inserting the battery.
.........................................................................................................................
WARNING
"THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBER
CR2025 MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE.
IT MUST THEREFORE ONLY BE FITTED IN EQUIPMENT DESIGNED
SPECIFICALLY FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE AND
MANUFACTURER.
THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE
ORIGINAL BATTERY, WITH THE CORRECT POLARITY CONNECTIONS
OBSERVED.
DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT
FOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED OF IN WASTE
PRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION."
.........................................................................................................................
~~~~~~~~~~~~~~~~~~~~~~~~~
ª Using the Remote Controller
1
Direct the Remote Controller to the Remote Control Sensor
of the Movie Camera and press an appropriate button.
≥Distance from the Movie Camera:Within approximately 5 metres
≥Angle:Within approximately 15o in the vertical and horizontal directions
from the central axis
≥The above operating ranges are for indoor use. Outdoors or under strong
light, the Movie Camera may not operate properly even within the above
ranges.
≥Within a 1-metre range, you can also use the Remote Controller on the side
(the [MENU] Button side) of the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used simultaneously, they can be operated
individually by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie Camera and that of the Remote
Controller do not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired
Remote Controller Mode. (l 13)
Setup on the Remote Controller:
[VCR1]:Press the [D] Button and [∫] Button simultaneously.
[VCR2]:Press the [E] Button and [∫] Button simultaneously.
1
≥When the battery in the Remote Controller is replaced, the mode is
automatically reset to [VCR1] Mode.
1
, pull out the Battery Holder.
1
2
9