Operation - NOMA ASHTON User Manual

OPERATION

Remote Control Operation Instructions
Install a 12 V battery into the remote control. Fasten the battery
cover screw after installation. To prevent damage to the remote
control, remove the battery if not used for long periods of time.
WARNING: Do not short-circuit, disassemble, heat up,
connect improperly, or dispose of used batteries in fire.
Do not recharge or mix batteries with used or other batt-
ery types. Immediately remove used batteries.
WARNING:
a) The batteries shall be disposed of properly, including
keeping them away from children; and
b) Even used batteries may cause injury.
01
Learning Process
NOTE: Should you desire to install more than one fan in your
home, please install one by one by following the steps
below to ensure each fan can be operated individually:
Step 1: Turn off the AC power to all fans to begin the learning process
on any single fan.
Step 2: Restore power to only one fan at a time for
pairing; the rest remain off by use of your wall-mounted
power switch.
Step 3: After the AC power is on, do not press any other button on the
remote control before pressing the
will cause the procedure to fail. Within 30 seconds of turning the fan's
AC power ON, press and hold the
learning function.
Once the receiver has detected the set frequency, the light will blink
two times when the pairing is complete.
Step 4: Repeat steps 1, 2, and 3 with each fan to ensure each fan can
be operated by the paired remote only, and without interfering with
each other.
(FAN ON/OFF) button. Doing so
button for 5 seconds to enter the
19
06