EGi 1111 Configuration Manual page 48

The equipment has two audio inputs:
If your computer detects continuous in the PIN_IN input, select it as the audio input.
If the computer detects the closure of the contact that goes to the RELAY_IN input, select the XLR (AUDIO
IN) balanced input.
If both are active, the entry PIN_IN takes precedence (PIN stands for Priority Input).
If we introduce the audio by PIN_IN, but the input control is set to RELAY_IN, we will not hear audio until the
RELAY_IN contact is closed.
48.
www.egiaudio.com
Power strip PIN_IN: Nominal level of 3 VRMS and a continuous signal superimposed from 4.5 to 7.5V. Compatible
with Millennium PIN outputs.
XLR AUDIO IN connector: Balanced, with nominal level of 1.2
(1306, XLR OUT), or from any balanced or unbalanced line audio level sound source.
Input control: Select which control input will trigger the analog input service.
–If we select PIN_IN, the audio will be heard when it detects continuous in the signal PIN_IN, with respect to
mass 4.
–If we select RELAY_IN, the audio of the input will be heard when the external contact between the
RELAY_IN and 4 strip is closed.
–If we select ANY_IN, the audio will be heard when either of the two previous conditions is met.
Priority level: In server mode it will be used to determine whether or not a particular message from the message
scheduler will interrupt the audio from this source. The assigned value must be between 0 and 12, with 0 being
the highest priority value.
. It can come from a Millennium zone module
VRMS