Watchguard AP 200 Setup Manual page 7

Ceiling/Wall Mounting Instructions
1. Position the mounting bracket on the wall or ceiling where you want to install the
WatchGuard AP device.
2. Use the mounting bracket as a guide to mark the position of the WatchGuard AP device on the
wall or ceiling.
3. Remove the mounting bracket and insert the large mounting screws into the marks you made
on the ceiling or wall.
4. Insert the long 5x32 screws through the bracket and into the mounting screws.
5. Insert the short 6x12 screws partway into the bottom of the device. Do not tighten the screws
completely. Keep the heads of the screws exposed to attach the device to the mounting
bracket.
If extra space is required between the device and the mounting bracket, use the
spacers and long 6x25 screws from the T-rail mounting hardware kit.
6. To attach the device to the mounting bracket, insert the screw heads from the device into the
slots in the mounting bracket, and rotate the device clockwise to lock the device in place.
4