Product Safety Certifications; Safety Warning - Watchguard AP 200 Setup Manual

REPRESENTS AND WARRANTS THAT (A) SUCH INDIVIDUAL IS DULY AUTHORIZED TO ACCEPT THE
WARRANTY ON BEHALF OF THE ENTITY AND TO BIND THE ENTITY TO THE TERMS OF THIS
WARRANTY; (B) THE ENTITY HAS THE FULL POWER, CORPORATE OR OTHERWISE, TO ENTER INTO
THE WARRANTY AND PERFORM ITS OBLIGATIONS UNDER THE WARRANTY AND; (C) THE
WARRANTY AND THE PERFORMANCE OF THE ENTITY'S OBLIGATIONS UNDER THE WARRANTY DO
NOT VIOLATE ANY THIRD-PARTY AGREEMENT TO WHICH THE ENTITY IS A PARTY. No change or
modification of the Warranty will be valid unless it is in writing and is signed by WatchGuard.
All WatchGuard products are designed and tested to meet strict safety requirements. These requirements
include product safety approvals and other global compliance standards. Please read the following
instructions carefully before operating the product, and refer to them as needed to ensure the continued safe
operation of your product. Additional information can be found in the electronic Hardware Guide.

Product Safety Certifications

The WatchGuard product is safety certified under the following standards:

CAN/CSA C22.2 No.60950-1-07+A1:2011

IEC 60950-1+Amd1 2nd Edition (2005)

UL 60950-1:2007 R12.11

EN 60950-1:2006+A11+A1+A12

Safety Warning


Do not place objects on the power cord.

Do not obstruct the ventilation openings. These openings prevent overheating of the machine.

Never push objects of any kind into slots or openings on this equipment. Making a contact with a
voltage point or shorting out a part may result in fire or electrical shock.

When removing or installing an appliance, follow the general installation safety instructions.
Disclaimer
WatchGuard shall not be held liable if the end user alters, modify, or repairs any WatchGuard hardware
appliance.
23