Watchguard AP 200 Setup Manual page 13

Hide thumbs Also See for AP 200:

Table of Contents

Pair the AP Device with the WatchGuard XTM

You must now use the WatchGuard XTM to pair the WatchGuard AP device with the XTM

and add the device to the wireless network.

1. Use Policy Manager or the Fireware XTM Web UI to edit the XTM device

configuration.

2. Select Network > Gateway Wireless Controller.

3. Enable the Gateway Wireless Controller, and save the configuration to the XTM device.

4. In the Gateway Wireless Controller, on the Access Points tab, click Refresh to discover the

AP device.

5. Select the unpaired Access Point and click Pair.

6. In the Pairing Passphrase dialog box, type the passphrase on the AP device. The default

passphrase is wgwap.

For detailed information about WatchGuard AP pairing, management, and configuration with

your XTM device, see the Wireless section of the Fireware XTM Web UI or WSM Help at

http://www.watchguard.com/help/documentation/xtm.asp.

Table of Contents

Ap 100