Before You Begin - Watchguard AP 200 Setup Manual

To connect directly to your WatchGuard AP device, you must physically connect an Ethernet
cable between the AP device and a computer, then connect to the Web UI on the AP device
with a web browser. After you have connected to the WatchGuard AP, you can configure the
device with an IP address to integrate with your network.
To configure the AP device, you must have these items:

Computer with an Ethernet interface

Web browser (Internet Explorer, Firefox, Safari, or another similar application)

Before You Begin

The default IP address of the WatchGuard AP device is 192.168.1.1.
To make sure you can connect to the WatchGuard AP device and complete the
configuration procedure, you must first configure your computer to use these settings:

IP address: 192.168.1.2

Subnet mask: 255.255.255.0

Gateway: 192.168.1.1
Connect to the WatchGuard AP
1. On your computer, open a web browser and type https://192.168.1.1 in the
location bar.
2. To log in to the WatchGuard AP, type the default password: wgwap
3. Configure your WatchGuard AP with an IP address and appropriate network settings so that
the device is on the same network as your WatchGuard XTM device.
When the WatchGuard AP is assigned an IP address, the WatchGuard XTM can connect to
the AP device by automatic discovery.
9