Table of Contents
Advertisement
Connect the Ethernet Power Injector
To connect an Ethernet Power Injector to the WatchGuard AP device:
1. Attach a region-specific plug to the Ethernet Power Injector.
2. Plug the Ethernet Power Injector into an AC power source.
3. Connect a straight-through Ethernet cable from your network backbone (for example, a router,
switch, or hub) to the IN connector on the Ethernet Power Injector.
4. Connect a straight-through Ethernet cable from the WatchGuard AP device Ethernet interface
to the OUT connector on the Ethernet Power Injector.
Ethernet Power Injector Specifications
WatchGuard Part #
Specification
AC Input Voltage Rating
Output Voltage
Output Power
Ethernet Interfaces
Region-specific
Adapter Plugs
18
Ethernet Power Injector
WG003000
IEEE 802.3af
100 to 240VAC
56V
15.4W
In: RJ-45 for 10/100 Mbps
Out: RJ-45 for 10/100 Mbps and 56V DC
Voltage on pins 4-5 (+) and 7-8 (-).
US, EU, UK, AU
Advertisement
Table of Contents
