Table of Contents
Advertisement
Installing and Configuring the Edge Switch 2/32
A right-click in the Speed column allows you to choose from a menu to set all
ports to 1 Gb/sec, 2 Gb/sec, or Navigate.
g. Port Binding—Click this check box to display a check mark and enable
WWN binding for the port. This allows only a specific device to attach to the
port. This device is specified by the WWN or nickname entered into the
Bound WWN column. With the check box cleared, any device can attach to
the port even if a WWN or nickname is specified in the Bound WWN
column.
or
Bound WWN—Enter a world wide name (WWN) in the proper format
(xx.xx.xx.xx.xx.xx.xx.xx) or a nickname configured through the Product
Manager application. The device with this WWN or nickname will have
exclusive attachment to the port if Port Binding is enabled. If a valid WWN
or nickname is not entered in this field, but the Port Binding check box is
checked (enabled), then no devices can connect to the port. If you enter a
WWN or nickname in this field and do not place a check in the Port Binding
check box, the WWN or nickname will be stored, and all devices can connect
to the port.
2. Use the vertical scroll bar as necessary to display additional port information rows
(up to 32 ports).
3. Click Activate to save the configuration information and close the dialog box.
Configure Ports (S/390 Mode)
If the switch is set to S/390 mode, perform this procedure to enable extended distance
operation and LIN alerts for Fibre Channel ports. Then continue to
Addresses (S/390
blocked or unblocked, and define the control unit port (CUP).
To configure switch ports:
1. At the Hardware View page for the selected switch, choose Configure > Ports.
The Configure Ports dialog box (S/390 mode) displays, as shown in
2-34
All manuals and user guides at all-guides.com
Mode)" on page 2–36 to define port names, configure ports as
"Configure Port
Figure
edge switch 2/32 installation guide
2–23.
Advertisement
Table of Contents
