Configure Port Addresses (S/390 Mode) - HP StorageWorks edge switch 2/32 Installation Manual

Installing and Configuring the Edge Switch 2/32
e. Bound WWN—Enter a World Wide Name (WWN) in the proper format
(xx.xx.xx.xx.xx.xx.xx.xx) or a nickname configured through the Product
Manager application. The device with this WWN or nickname will have
exclusive attachment to the port if WWN Binding is enabled. If a valid WWN
or nickname is not entered in this field, but the WWN Binding check box is
checked (enabled), then no devices can connect to the port. If you enter a
WWN or nickname in this field and do not place a check in the WWN
Binding check box, the WWN or nickname will be stored, and all devices can
connect to the port.
2. Use the vertical scroll bar as necessary to display additional port information rows
(up to 64 ports).
3. Click Activate to save the configuration information and close the dialog box.

Configure Port Addresses (S/390 Mode)

If the switch is set to S/390 mode, perform this procedure to access the switch matrix
and define Fibre Channel port names, configure ports as blocked or unblocked, and
define the CUP name. Perform this procedure in conjunction with
(S/390 Mode)" on page 2–34.
To configure switch port addresses:
1. At the Hardware View page for the selected switch, choose Configure >
Addresses > Active. The Configure Addresses — Active dialog box displays, as
shown in
2-36
All manuals and user guides at all-guides.com
Figure 2–24.
"Configure Ports
edge switch 2/32 installation guide