Table of Contents
Advertisement
A.3 RIP Commands
RipSend
Syntax: RipSend <e-ether, c-cable> <1 - doNotSend, 2 - v1, 3 - v2-broadcast, 4 - v2-multicast>
Description: Set RIP advertisement sending on specified interface.
RipReceive
Syntax: RipReceive <e-ether, c-cable> <1 - v1, 2 - v2-multicast, 3 - v2-broadcast, 4 -
doNotRecieve>
Description: Set RIP advertisement receiving on specified interface.
RipAuthType
Syntax: RipAuthType <e-ether, c-cable> <1 - none, 2 - password, 3 - md5>
Description: Set RIP authentication type.
RipMd5AddKey
Syntax: RipMd5AddKey <e-ether, c-cable> <key-id (0-255)> <key-string (max length is 16
bytes)>
Description: Add MD5 Authentication key.
RipMd5DelKey
Syntax: RipMd5DelKey <e-ether, c-cable> <key-id (0-255)>
Description: Delete MD5 authentication key.
RipShow
Syntax: RipShow
Description: Show current RIP status.
RouteShow
Syntax: RouteShow
Description: Show routing table.
A.4 Static Route Commands
staticRouteAdd
Syntax: staticRouteAdd <name> <target network> <target network mask> <gateway IP>
Description: Add static route.
staticRouteDel
Syntax: staticRouteDel < name >
Description: Set RIP advertisement receiving on specified interface.
staticRouteErase
Syntax: staticRouteErase
Description: Erase all static routes.
staticRouteShow
Syntax: staticRouteShow
Description: Show all static routes.
- 31 -
Advertisement
Table of Contents
