Table of Contents
Advertisement
Replacing the I/O bracket
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the I/O bracket, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Replacing the computer stand" on page 96.
4. Remove the computer cover. See "Removing the computer cover" on page 101.
5. Remove the system-board shield. See "Replacing the system-board shield" on page 102.
6. Locate the I/O bracket. See "Computer components" on page 33.
7. Remove the I/O bracket by releasing the two tabs
Figure 64. Removing the I/O bracket
8. Align the three holes in the new I/O bracket with the corresponding tabs
Figure 65. Installing the I/O bracket (for M700z)
1
and pivoting the I/O bracket outward.
1
.
Chapter 9
Installing or replacing hardware
on the chassis.
121
Advertisement
Table of Contents
