Table of Contents
Advertisement
Use the instructions shipped with the option to help you make the connection and install any software
or device drivers that are required for the option.
Replacing the computer stand
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the computer stand, refer to the following topics:
•
"Replacing the full-function monitor stand (for M700z)" on page 96
•
"Replacing the tilt-only monitor stand" on page 98
•
"Replacing the UltraFlex II Stand (for M800z)" on page 99
Replacing the full-function monitor stand (for M700z)
To replace the full-function monitor stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Press the retaining latch
remove full-function monitor stand from the computer.
Figure 20. Removing the full-function monitor stand
96
ThinkCentre M700z and M800z Hardware Maintenance Manual
1
on the full-function monitor stand as shown to disengage the latch. Then,
Advertisement
Table of Contents
