Vacuuming hard surfaces
Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Vacuuming carpeted floors
Work without the hard surface insert.
Illustration
Use the surrounding air separator to
adapt the suction force.
Note:
Close the surrounding air separator
again after use!
Wet vacuuming
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full, a float closes
the suction opening, and the appliance
works at a higher speed. Switch off the ap-
pliance immediately, and empty the con-
tainer.
Attach the accessories to vacuum mois-
ture or wetness to the suction tubes or
directly to the handle.
Switch on suction (position I).
Illustration
Open the surrounding air separator if
water is suctioned from a tank. Close it
again after use.
Empty the full reservoir (refer to chapter
"Empty reservoir").
Shutting down
Turn off the appliance.
Empty the full reservoir (refer to chapter
"Empty reservoir").
Rinse the reservoir thoroughly with
clear water.
Remove the accessories from the appli-
ance after each use and disassemble
the hose, nozzle and extension tubes.
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
Flush the accessories separately under
running water and let air dry.
Clean the foam filter under running wa-
ter; let it dry before reinserting it.
Leave the appliance open to let it dry.
Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.
Maintenance and Care
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
Warning
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Cleaning the device
With an uneven spray jet.
Illustration
Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
1 x year or as needed.
Illustration
Turn the lock and loosen it. Take out the
sieve and rinse it with water.
No water exiting from nozzle
Fill up fresh water reservoir.
Check the fresh water reservoir for cor-
rect fit.
Detergent pump defective, contact cus-
tomer service.
Spray stream uneven
Clean the spray nozzle of the spray ex
floor nozzle.
– 10
EN
reservoir
Faults
17