Positionering Van De Lichttoren - Lighting Tower Positioning; Aardaansluiting - Earthing - Generac Mobile CTF 10m Owner's Manual

Table of Contents

Advertisement

CTF 10m

13.2 POSITIONERING VAN DE LICHTTOREN - LIGHTING TOWER POSITIONING

Het is aanbevolen om de structuur op een
stabiele
plaats
op
consistentie van het terrein te controleren
om een veilige steun op de stabilisatoren te
verzekeren.
Wanneer de lichtmast op een generator groep
aangesloten wordt, kies een open goed
geventileerde plaats zodat de uitlaatgassen ver
van de werkplaats terecht komen.
Controleer of er een volledige luchtverversing
plaatsvindt en of de uitgestoten warme lucht
niet opnieuw in de groep terecht komt: Dit zou
een gevaarlijke temperatuurstijging tot gevolg
hebben.
Plaats een hekken op 2 meter afstand rond de
lichtmast om te verhinderen dat onbevoegd
personeel bij de machine komt.
13.3 AARDAANSLUITING – EARTHING
De aanwijzingen en vereisten vermeld in
paragraaf 7.3 moeten worden nageleefd.
Voer indien nodig de aardaansluiting van de
groep middels de klem (12) uit.
Indien nodig moet de aardaansluiting van de
groep worden uitgevoerd via een koperen
kabel met een doorsnede van minstens 6 mm².
De fabrikant acht zich niet aansprakelijk
voor eventuele schade als de groep niet is
geaard.
te
stellen,
en
de
 It is recommended to place the structure
in a
stable
place, by verifying the
consistence of the earth to allow a sure
support to the stabilizers.
Choose an open location and very ventilated
taking care that the discharge of the exhaust
gases happens far from the work-zone.
Check that there is a complete change of air
and the hot air expelled don't circulate into
the group in way that it's caused a dangerous
elevation of the temperature.
Predispose the barriers placed to 2 meters of
distance around the lighting tower in order to
prevent
to
the
approach itself the machine.
Prescriptions and requirements listed at
chapter 7.3 shall be fulfilled.
If required, connect the unit to the true earth,
through the MET (Main Earth Terminal) (12)
Connection to true earth, if needed, shall be
made by means of a copper cable with a
minimum cross-section of 6 mm².
The manufacturer is not responsible for
any damage caused by failure of the
earthing.
23
staff
non-authorized
TL199-01-01-01
05-03-2018
Nederlands - English
to

Advertisement

Table of Contents
loading

Table of Contents