Instructions; Installation; Founda On Requirements - Dexter Laundry T-350 Operators Manual Installation & Operation Instructions

7 Instruc ons
7.1 Installa on
INSTALLATION AND SERVICING
INSTRUCTIONS ARE FOR USE BY
QUALIFIED PERSONNEL ONLY. TO
AVOID INJURY AND ELECTRICAL SHOCK
DO NOT PERFORM ANY SERVICING
OTHER THAN THAT CONTAINED IN THE
OPERATING INSTRUCTIONS, UNLESS
QUALIFIED.

7.1.1 Founda on Requirements

T-300 and 400:
This machine is designed for use on or over bare concrete floor - not to be used above
combustible flooring, such as carpet or wood. The washer must be securely bolted to a
substantial concrete floor or mounted upon a suitable base that is securely bolted to a
substantial concrete floor. Grouting is highly recommended, especially to the concrete surface.
See Machine Grouting section for details.
T-350, 450, 600, 650, 750, 900:
This machine is designed for use on or over bare concrete floor - not to be used above
combustible flooring, such as carpet or wood. The washer must be securely bolted and
grouted to a substantial concrete floor or mounted and grouted upon a suitable base that is
securely bolted and grouted to a substantial concrete floor. See Machine Grouting section for
details.
Allow a minimum 610 mm (24 inches) of clearance behind the rear of the machine to provide
access for motor service.
Installation on an isolated pad is NOT recommended. Consult a structural engineer for
installations that will not be tied to a surrounding floor.
8514-301-001 REV PR
WARNING
CARE MUST BE STRESSED WITH ALL
FOUNDATION WORK TO ENSURE A
STABLE UNIT INSTALLATION,
ELIMINATING POSSIBILITIES OF
EXCESSIVE VIBRATION.
All washers must be installed in
accordance with all local, state and
national building, electrical, plumbing and
other codes in effect in the area.
Electrical safety of these washers has
been evaluated to the requirements of
European standard EN 60204-1.
WARNING
INFORMATION
18