Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Autonomous Anti-collision Smartdesk
Summary of Contents for Autonomous Anti-collision Smartdesk
- Page 1 Smartdesk - Anti-collision Edition Assembly instructions...
- Page 2 Content 1. Caution.....................1 2. BOM Information and Tools..............2 3. Installation Instructions..............3 4. Operating Manual for Control Unit............5 5. Code Meaning..................9 6. Troubleshooting................9 7. Technical Data..................9...
-
Page 7: Adding A New Device
Control the height of your SmartDesk After successfully connecting the Bluetooth, with your smartphone or smart device. input the Wi-Fi name and password. • Now the Autonomous app is connected to the SmartDesk. Assembly Introduction Videos Set Up Devices .. -
Page 8: Saving Position
NOTE: It is necessary reset manually or unplug after the initial installation. Keep pressing "down" key until the handset display shows "E-1" and "rES" alternately and then release the key. Keep pressing the “down” key again. The desktop will move slowly down and return back till the display shows "60". - Page 9 Modified High and Low Limitation Positions This function can be used to limit the movement area of desktop, when the drawer is underneath or any shelf is above the desktop. Once it is set, the new High or Low limitation position will be stored. NOTE: This function is not recommended for ordinary operation.
-
Page 10: Plug Detection
Changing the Desktop Height Displayed The function enables you to change the height shown on the display based on the actual measurement. NOTE: Before using this function, execute the Manual Reset procedure. Press and hold "M" key till the display shows "Ur" and "oFF" alternately. Press “up”... -
Page 11: Troubleshooting
Code Meaning and Troubleshooting Code Meaning Manual resetting Refer to the progress of manual reset. Remove the load on desktop till it less than Overloading 1000N / 102KG / 225LBS for further operation. It can be used normally after removing the Anti-Collision function obstacle.
Need help?
Do you have a question about the Anti-collision Smartdesk and is the answer not in the manual?
Questions and answers