System Board - HP Stream 14 Pro G3 Service Manual

System board

Description
Intel Celeron N3060 processor, 4 GB system memory, 64 GB eMMC hard drive, and a non-Windows
operating system
Intel Celeron N3060 processor, 4 GB system memory, 64 GB eMMC hard drive, and the Windows 10
operating system
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the WLAN module (see
6. Remove the heat sink (see
Remove the system board:
1. Disconnect the following cables from the system board:
(1): Power button board cable
(2): Display cable
(3): Power connector cable
(4): Keyboard cable
(5): Battery cable
(6): TouchPad cable
(7): RTC battery cable
Bottom cover on page
WLAN module on page
Heat sink on page 28).
22).
25).
Component replacement procedures
Spare part number
928552-001
928552-601
31