Rear View - Lenovo ThinkSystem SR675 V3 System Configuration Manual

Install PCIe adapters, particularly network adapters to these slots. These PCIe slots support the following
configuration:
• PCIe Gen5 x16, FH/FL
7 E3.S 1T hot-swap drive bays (0 to 3)
Install E3.S 1T hot-swap drives to these bays. See "Install an EDSFF hot-swap drive" in ThinkSystem SR675
V3 User Guide or Hardware Maintenance Guide for more information.

Rear view

The rear of the server provides access to several components, including the power supplies, PCIe adapters,
serial port, and Ethernet port.
Figure 5. Rear view
Table 5. Components on the rear view
PCIe riser 1 (PCIe slot 15-16)
1
PCIe riser 2 (PCIe slot 20-21)
2
Power supply units
3
NMI button
4
1 PCIe riser 1 (PCIe slot 15-16)
Install PCIe adapters to the PCIe riser. These PCIe slots support the following configuration:
• PCIe x16 75W, FH/HL
PCIe riser 2 (PCIe slot 20-21)
2
Install PCIe adapters to the PCIe riser. These PCIe slots support the following configuration:
• PCIe x16 75W, FH/HL
3 Power supply units
Install power supply units to these bays, connect them to power cords. Make sure the power cords are
connected properly. Following are the power supplies supported by this system:
• 1800-watt Platinum, input voltage 230 Vac
USB 3.2 Gen 1 (5 Gbps) connectors (total of three
5
connectors)
VGA connector
6
XCC system management port (1 GB RJ-45)
7
OCP module (slot 27)
8
Chapter 2
.
Server components
19