Integrated Peripherals - Lanner electronics EM-535 Series Manual

3.10 I P
NTEGRATED
When you select the "INTEGRATED PERIPHERIALS" on the main program, the screen display will
appears as:
Integrated Peripheral Setup Screen
IDE HDD Block Mode
Primary IDE Channel
Master Drive PIO Mode
Slave Drive PIO Mode
Secondary IDE Channel
Master Drive PIO Mode
Slave Drive PIO Mode
IDE Primary Master UDMA
IDE Primary Slave
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
KBC input clock
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
Onboard IR Controller
IDE HDD Block Mode : The Default setting is "Enabled".
performance by making multi-sector transfers instead of one sector per transfer. Most IDE drives,
except the very early design, have Block Mode transfer feature.
Primary IDE Channel : Select "Enabled" to activate the on-chip IDE interface.
Master Drive PIO and Slave Drive PIO : There are six options namely "Auto", "Mode 0", "Mode
1","Mode 2", "Mode 3" and "Mode 4". The default setting is "Auto".
will automatically set the mode to match the transfer rate of hard disk. If the system won't boot up
when set to "Auto", set it manually to the lower mode (e.g. From Mode 3 to Mode 2). All IDE drives
ERIPHERALS
ROM PCI / ISA BIOS (2A434L7H)

INTEGRATED PERIPHERALS

AWARD SOFTWARE, INC.
: Enabled
: Enabled
: Auto
: Auto
: Enabled
: Auto
: Auto
: Auto
UDMA : Auto
: Auto
: Auto
: 8MHz
: Enabled
: 3F8/IRQ4
: 2F8/IRQ3
: Disabled
EM-535 / 45
Onboard Parallel Port
Parallel Port Mode
Onboard Serial Port 3
Serial Port 3Use IRQ
Onboard Serial Port 4
Serial Port 4 Use IRQ
Onboard Parallel Port 2
Parallel Port 2 Use IRQ
áâàß
ESC : Quit
F1 : Help PU /PD/+/-
F5 : Old Values ( Shift ) F2
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
This feature enhances the hard disk
When it is set to "Auto", the BIOS
AWARD BIOS SETUP
: 378/IRQ7
: SPP
:3E8H
:IRQ10
:2E8H
:IRQ3
:278H
:IRQ11
: Select Item
: Modify
: Color