Lanner electronics EM-535 Series Manual page 52

AWARD BIOS SETUP
should work with PIO mode 0.
IDE Primary Master UDMA,IDE Primary Slave UDMA: Ultra DMA /33 implementation is possible only if
your IDE hard drive supports it and the operating environment includes a DMA driver(Window 95 OSR2
or a third-party IDE bus master driver). If your hard drive and your system software both support Ultra
DMA/33, select Auto to enable BIOS support.
Onboard FDC Controller : Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If you install an add-in FDC or the system has no floppy
drive, select Disabled in this field.
Onboard Serial Port 1 / 2 : These options are used to assign the I/O addresses for the two on-board
serial ports. They can be assigned as follows:
Auto [Default]
3F8 / IRQ4
2F8 / IRQ3
3E8 / IRQ4
2E8 / IRQ3
Disabled (Disable the onboard serial port)
Onboard Parallel Port : This option is used to assign the I/O address for the onboard parallel port. The
options are "378/IRQ7" (defaults), "278/IRQ7", "3BC/IRQ7" and "Disabled"
parallel port). Note: Printer port always use IRQ7 when set to "378/IRQ7" or "278/IRQ7", or from
"3BE/IRQ7" to "Enabled".
Parallel Port Mode: There are four options "Normal" (default), "ECP", "ECP/EPP" and "EPP/SPP".
Change the mode from "Normal" to the enhanced mode only if your peripheral device can support it.
When it is set to ECP mode, the printer port always uses DMA3.
EM-535 / 46
(disable the onboard