Lanner electronics EM-535 Series Manual page 55

CHAPTER 4.
anufacture default BIOS supports both VGA and LCD(FEM-535A.BIN).If you want to
M
use TV or RGB terminals, please change BIOS as following:
4.1 BIOS LIST(
DIRECTORY CD
B N
IOS
-535
FEM
-535
FEM
-535
FEM
4.2 A BIOS F
WARD
It is important to have the system boot cleanly before executing a flash BIOS upgrade
since it should not be run under any protected mode environments. (make sure that
EMM386.EXE is not being loaded in your config.sys file)
If you have a Windows 95 startup diskette, make a copy of it. Use this new copy to
flash the BIOS. Proceed to step (4).
If you do not have a Windows 95 startup diskette, here are the instructions to make
one:
l Insert a blank floppy in the A: drive.
1. Go to Add/Remove Programs in the Control Panel.
2. Click on the Start Menu and highlight Settings.
3. From the next menu click on Control Panel.
4. Click on Add/Remove Programs.
(1) Select the Startup Disk tab at the top of the screen.
(2) Place a blank formatted diskette in the A:\drive.
(3) Click on Create Disk.
(4) Copy awardflash.exe
(5) Copy bios file.*bin form driver CD-ROM into diskette.
How to create a startup disk from DOS:
Insert a blank floppy in the A: drive.
Type "Format a: /s"
l Reboot your system with the bootable floppy disk in your A: drive.(You might have
to change the boot up sequence (in BIOS setup) from C:A: to A:C: before reboot.)
l Confirm the BIOS filename on the diskette matches the name on the manual.
To confirm the bios filename do a directory command on the A: drive (DIR A: /W
\ -535\
EM
AME
.
A BIN
.
B BIN
.
C BIN
I
LASH NSTRUCTIONS
EM-535 / 49
BIOS UPDATED
)
BIOS
F
UNCTION
LCD
TV
RGB