Page 1
RHT-P10 Transmitter INSTRUCTIONS MANUAL - V2.0x A NOVUS AUTOMATION...
Page 2
INSTALLATION MECHANICAL INSTALLATION The electronics module of the RHT-P10 must be fixed to the wall. The remote sensor module, on the other hand, must be inserted into a threaded flange. By removing the cover of the transmitter electronic module, the user has access to the two fixing holes, as shown in the figure below: Figure 1 –...
Page 3
• Place it within an 80 °C (176 °F) (±10 °C) oven for 24 hours. • Place it for 48 hours in a place with a temperature between 20 °C (68 °F) and 30 °C (86 °F) and humidity over 75 % RH. • Place the sensor back in the capsule. NOVUS AUTOMATION...
Page 4
6. Apply: When pressed, allows you to send the configuration to the connected transmitter. Note: The factory default configuration is (unless otherwise specified or ordered): Measuring ranges: 0 to 100 °C (32 to 212 °F) and 0 to 100 % RH. • 0 °C (32 °F) of correction zero. • NOVUS AUTOMATION...
Page 5
The software will recognize the RHT-P10 model, read its configuration, and make it available to the user. • In the "Options" menu, enter "Humidity Reading Type" (only available when an RHT-P10 model is detected) and select the "Dew Point" option. •...
Page 6
Electronic circuit housing: IP65 Protection Sensor capsule: IP40 Cable entrance Compress fitting PG7. Sensor (RHT-P10): See Figure 13. Operating limits Maximum differential pressure: 10 Bar (145 PSI). Electronic circuit (RHT-P10): Electronic circuit Operating temperature: -10 to 65 °C (14 to 149 °F), 0 to 95 % RH Storage temperature: -20 to 80 °C (-4 to 176 °F)
Page 7
MEASUREMENT ACCURACY AND OPERATIONAL LIMITS OF THE SENSORS Figure 13 – Humidity and temperature accuracies NOVUS AUTOMATION...
Page 8
WARRANTY Warranty conditions are available on our website www.novusautomation.com/warranty. NOVUS AUTOMATION...
Need help?
Do you have a question about the RHT-P10 and is the answer not in the manual?
Questions and answers