Max 10660 Instruction Manual page 62

Installation of the � exible shaft
1. Remove the shaft collar.
3. Raise the handle end 3. Raise the handle end
of the � exible shaft
and shake gently until
the inner � exible shaft
protrudes from the
� tting collar.
4. Insert the inner � exible shaft into the collet
then tighten the collet nut.
5. Screw the � exible shaft
� tting collar onto the
rotary tool.
6. Insert the hex key into the
hole on the handle.
8. Tighten the nut and check all � ttings to ensure
they are securely fastened. they are securely fastened.
62
2. Loosen the collet nut.
7. Loosen the collet nut and then insert 7. Loosen the collet nut and then insert
the shank of the accessory into collet. the shank of the accessory into collet.