Max 10660 Instruction Manual page 61

Engraving bit
Used for � ne engraving in various materials.
If engraving metal you should choose a low
speed and work as if you were engraving
hard wood. Also work at low speed when
engraving plastic, since the frictional heat
can melt or deform the plastic.
Sanding rollers
Used for sanding, smoothing and forming of
wood and � bre glass. When sanding belt is
worn, remove it from the rubber roll and � t a
new sanding belt.
Honing stone
Used for cleaning and forming grinding
stones
Polishing discs
Used for polishing e.g. metal. Use only the
edge of the disc, otherwise the item might
get scratched from the thread retaining the
disc on the shaft.
Cutting discs
Used for cutting metal, � ne wood and plastic.
Can also be used for cutting a slot in a bolt
so that unscrewing the bolt is easier. Make
sure not to force the cutting disc, otherwise it
might burst.
Sanding disc
Used for sanding, smoothing and forming of
wood and � bre glass.
GB
61