Installing The Midi Driver (Oms) - Roland Sound Canvas SK-500 Owner's Manual

When you turn on the SK-500, the following messages appear, but as the
driver (software) required by the sound module will be installed afterwards
from the included CD-ROM, use the procedures described below in
response to each of the messages that come up.
When the message "Drivers needed for the USB device 'Unnamed
Device' are not available. Would you like to look for these drivers over
the Internet?" appears:
-> Click [Cancel].
When the message "The software needed to use the USB device
'Unknown Device' cannot be found. Please refer to the device
documentation to install the necessary software." appears:
-> Click [OK].

Installing the MIDI Driver (OMS)

Install the MIDI Driver (OMS) on the Macintosh. Place the SK-500 CD-ROM
in the CD-ROM drive.
1
On the SK-500 CD-ROM, open "English" - "OMS" -
"OMS2.3.8" and double-click on the "Install OMS 2.3.8" icon
in the folder.
fig.38
2
Confirm the location where the driver is to be installed, then
click on [Install].
Installing OMS and USB MIDI Driver on Macintosh
45