How To Assemble Your Ceiling Fan - Fanimation Zonix Wet FP4640BBLW Manual

1. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 5. (Figure 1)
2. The fan comes with blue, black, and white 54
wires. Separate and untwist the three wires. Route
the wires the wires through the downrod.
NOTE: Y
3. Loosen the two setscrews in the downrod support.
Align the clevis pin holes in the downrod with the
holes in the downrod support. Install the clevis pin
and secure with the hairpin clip. Be sure to push the
straight leg of the hairpin clip through the hole near
the end of the clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin. The hairpin
clip must be properly installed to prevent the clevis
pin from working loose. Pull on the downrod to make
sure the clevis pin is properly installed. (Figure 3)
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
4. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy with open side facing
up. (Figure 4)
5. Reinstall the hanger ball on the downrod as follows.
Route the three 54 wires and cable through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble. (Figure 5)

How to Assemble Your Ceiling Fan

(Figure 2)
Hanger
Ball
y
Downrod
Support
Clevis Pin
Ceiling
Canopy
Motor
Coupling
Cover
6
Pin
Setscrew
Figure 1
Black, Blue and
White Lead
Downrod
Figure 2
Hairpin Clip
Setscrew (2)
Figure 3
Canopy Screw
Cover
Figure 4
Figure 5