Page 2
Gather Your Eggs... Back Panel Slats Mega-Slats Side Panel Supports Front Panel Legs Bracket Bolt 6mm x 25 Hex Bit Ratchet Note: Please retain all boxes until you are certain that your product isn’t damaged and that you do not wish to return it. Disposal of boxes may prevent/delay our ability to resolve your request.
Page 3
Step 1: Prepare Center Supports Assemble on a soft surface to protect from scratches. Lay down the front panel and rear panel. Lay down the center supports between the front and rear panel.
Page 4
Step 2: Attach Center Supports Insert a center support into the alcove in the back panel. Insert the bracket bolts. Use the ratchet and hex bit to tighten all four brackets.
Page 5
Step 3: Attach Side Panels Position the side panels next to the frame with the brackets facing up. Ley the mega- slats down on the frame, aligned with the brackets on the side panels. Insert one end of the mega-slat bracket forks into the corresponding slots in the side panel bracket.
Page 6
Step 4: Attach Legs Position a leg near each corner of the bed frame. Lift the side panel to align with the corresponding bracket on the leg. Slide the bracket forks on one side of the leg into the bracket in the side panel. Line up the adjacent bracket and insert.
Page 7
Step 5: Insert Slats Insert all the slats by first sliding them into their alcoves, and then laying flat on the supports. Repeat for all slats. Step 6: Add Your Bedding Add your mattress and bedding, and relax! DONE! DONE!
Page 8
Fabric Care Instructions Cleaning Codes Each fabric type has a specific cleaning code which can be found on the Free Swatch Page. SOLVENT OR WATER CLEANAB LE (S/W) Spot clean with upholstery shampoo, foam from a mild detergent, or a mild dry cleaning solvent. WATER CLEANAB LE (W) Spot clean fabric with a water-based shampoo or foam upholstery cleaner.
Need help?
Do you have a question about the HAVEN BED and is the answer not in the manual?
Questions and answers