Before You Begin Using The Fa-66 With Your Macintosh (Mac Os X Users) - Edirol FA-66 Owner's Manual

Before you begin using the FA-66
with your Macintosh
If you are using the FA-66 with Windows, please read
"Installing the driver (Windows)" (p. 24).
If you're using the FA-66 with Mac OS X, you don't need to
install a driver.
Simply connect the FA-66 to your Macintosh as described
below.
1
With the FA-66 disconnected, start up your Macintosh.
2
Use a FireWire (IEEE 1394) cable to connect the FA-66 to
your Macintosh.
1.
With the FA-66's power switch off, connect the power
cord to it.
2.
Plug the AC adaptor cable into an AC outlet.
3.
Use a FireWire (IEEE 1394) cable to connect the FA-66
to your Macintosh.
3
Turn on the FA-66's power switch.
The driver will be installed automatically.
Next, you need to make audio device and MIDI device
settings.
18
(Mac OS X users)
Once the connections have
been completed, turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
speakers and other devices.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
Once the connections have
been completed, turn on
power to your various devices
in the order specified. By
turning on devices in the
wrong order, you risk causing
malfunction and/or damage to
speakers and other devices.