Installation - HIKVISION TURBO HD C5T Series User Manual

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with

your power output to avoid the damage.
Make sure the wall is strong enough to withstand

three times the weight of the camera and the
bracket.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact

your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
2.1.1 Ceiling/Wall Mounting without Junction Box
Before you start:
The installation steps of ceiling mounting and wall
mounting are similar and the following takes ceiling
mounting as an example to describe the steps.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes and the cable hole (optional) in
the ceiling/wall according to the drill template.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Route the cables through the cable hole, or the side
opening.
4. Install the camera to the ceiling with supplied
screws.
Figure 2-2 Install the Camera to the Ceiling
120°
Figure 2-1 Drill Template
120°