HIKVISION TURBO HD C5T Series User Manual page 6

Note:
The supplied screw package contains self-tapping

screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are

required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Pan Position
[0°to 360°]
1). Loosen the P screw to adjust the pan position [0°
to 360°]. Tighten the screw after completing the
adjustment.
2). Loosen the T screw to adjust the tilt position [0°
to 90°]. Tighten the screw after completing the
adjustment.
3). Loosen the R screw and rotate the camera [0° to
360°]. Tighten the screw after completing the
adjustment.
2.1.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole in the
ceiling/wall according to the holes of the drill
template.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Take apart the junction box, and align the screw
holes of the camera with those on the junction
box's cover.
4. Fix the camera on the junction box's cover.
Figure 2-5 Fix the Camera on the Junction Box's cover
P
T
Tilt Position
[0° to 90° ]
R
Figure 2-3 3-axis Adjustment
Figure 2-4 Drill Template
Rotation Position
[0° to 360°]