Table of Contents
Advertisement
36" (914mm) Min
to combustible
materials
36 ¾" Max (933mm)
⅞
35
" Min (911mm)
as defined in the
"National Fuel Gas Code"
(ANSI Z223.1, Current
Edition). Clearances from
non-combustible materials
are not part of the ANSI
Z21.1 scope and are not
certified by CSA.
Clearances of less than
12" (305 mm) must be
approved by the local
codes and/or by the local
authority having
jurisdiction.
English 6
31 ¼" (794mm)
29
" (740mm)
.
High Shelf
25
maximum
recess depth
26
48 ¾" (1238mm)
36" (914mm) min
to combustible
materials
36 ¾" Max (933mm)
⅞
35
" Min (911mm)
Combustible Materials
2¾" (70mm)
12" (305mm)
9"
Low Back
Guard
(229mm)
" (638mm)
Combustible Back Wall
⅞
" (683
mm)
Figure 2: Installation Clearances with High Shelf or Low Backguard
12" (305mm) min
to combustible
surface with Flush
Island Trim
Flush Island Trim
Figure 2b: Installation Clearances with Included Flush Island Trim
21
" (537mm)
as defined in the "National Fuel Gas
Code" (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials
are not part of the ANSI Z21.1 scope and are
not certified by CSA. Clearances of less than
12" (305 mm) must be approved by the local
codes and/or by the local authority having
jurisdiction.
Combustible Materials
Note: For Flush Island
Trim installations,
counter surface should
have a cantilever edge
meeting the back section
of the Flush Island Trim
accessory.
Cantilever
Note: If an inner wall is
used under the cantilever
counter top, there should
be a 1/8" (3mm) gap from
the rear of the range to the
inner wall.
Advertisement
Table of Contents
