Table of Contents
Advertisement
Tools Needed for Installation of Anti-Tip Device:
•
Screwdriver, Phillips
•
Drill, electric or hand
•
Measuring tape or ruler
•
1/8" (3.17mm) drill bit (wood or metal; wall or floor)
•
3/16" (4.76mm) carbide-tipped masonry drill bit
(concrete or concrete block wall or floor)
•
3/16" (4.76mm) anchors, drywall or concrete, 4 each
(not required if mounting bracket is being attached to
solid wood or metal)
•
Hammer
•
Pencil or other marker
WARNING:
--
A child or adult can tip the range and be
killed.
--
Verify the anti-tip device has been
properly installed and engaged as per
installation instructions.
--
Ensure the anti-tip device is re-engaged
when the range is moved.
--
Do not operate the range without the anti-
tip device in place and engaged.
--
Failure to do so can result in death or
serious burns to children or adults.
See further Installation Instructions.
THERMADOR
Service Part
Qty
No.
415078
4
655355
1
Description
Screw, Phillips, #10 x 1½"
(38.1mm)
Anti-Tip Bracket
Important Installation Information:
•
Attach anti-tip bracket to a solid wood cabinet having a
minimum wall thickness of 3/4" (19mm). The thickness
of the wall or floor may require use of longer screws,
available at your local hardware store.
•
Use appropriate anchors when fastening the mounting
bracket to any material other than hard-wood or metal.
•
In all cases, at least (2) of the bracket mounting screws
must firmly fasten the anti-tip bracket to the floor, and
(2) of the mounting screws (or drywall anchors) must
firmly fasten the anti-tip bracket to the rear wall (see
Figure 12 and Figure 13).
Figure 12: Anti-tip Bracket Mounting Location
Mounting the Anti-Tip Bracket
1. Prepare holes at fastener locations as identified below:
•
For walls, wall studs, or floors composed of solid
wood or metal, drill 1/8" (3.17mm) pilot holes.
•
For walls or floors composed of drywall, sheet-rock
or other soft materials, drill 3/16" (4.76mm) holes to
a minimum depth of 1¾" (44mm), then tap plastic
anchors into each of the holes using a hammer.
•
For walls or floors composed of concrete or
concrete block, drill 3/16" (4.76mm) holes to a
minimum depth of 1¾" (44mm), then tap concrete
anchors into each of the holes using a hammer.
•
For walls or floors having ceramic tile covering, drill
3/16" (4.76mm) holes through the tile only, then
drill into the material behind the tile as indicated
immediately above.
3"
(76mm)
English 13
Advertisement
Table of Contents
