ADJ XS 400 User Instructions page 6

XS 400
ENTER to confirm. After pressing ENTER, press and hold the MENU
button for at least 3 seconds to activate.
3. When you have found your desired show press ENTER, then press
and hold the MENU button for at least 3 seconds to activate. After
you have set your desired show, it can be changed at any time using
the UP or DOWN buttons.
SOND -
Sound Active mode.
1. Press the MENU button until "SOND" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to activate sound active mode, or
"OFF" to deactivate sound active mode.
3. Press ENTER to confirm.
SOSE -
In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until "SOSE" is displayed, press ENTER.
2. A number between 5-255 will be displayed. Press the UP or DOWN
buttons to adjust the sound sensitivity. 5 being the least sensitive,
and 255 being the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
LAST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, interrupted, or power is lost,
the operating mode chosen in the setup is the running mode
the fixture will go into when the DMX signal is lost. You can
also set this as the operating mode you would like the unit to
return to when power is applied.
1. Press the MENU button until "LAST" is displayed, and either
"BLAC", "HOLD", or "SHOU" will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP
or DOWN buttons to choose an operating mode you would like the unit
ADJ Products, LLC - www.adj.com - XS 400 User Manual Page 10
System Menu XS 400
to start up in when power is applied or the DMX signal is lost.
• HOLD - If the DMX signal is lost the fixture will stay in the last DMX
setting. If power is applied and this mode is set, the unit will automati-
cally go into the last DMX set up.
• SHOU (Show Mode) - If the DMX signal is lost or power is applied,
the unit will automatically run a built-in show.
• BLAC (Blackout) - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
3. Press ENTER to confirm your desired set up.
DIND -
1. Press the either the MENU button until "DIND" is displayed, press
ENTER. 1 of 5 dimmer curves will be displayed. "STAN" (standard),
"STAG" (stage), "TV" (TV), "ARCH" (architectural), or "THE" (theatre).
2. Press the UP or DOWN buttons to find your desired dimmer curve
and press ENTER to confim and exit.
PINT
rotation)
1. Press the MENU button until "PINT" is displayed, press ENTER.
Either "On" or "Off" will be displayed.
2. To activate the Pan inversion (counter-clockwise rotation) press the
UP or DOWN buttons until "On" is displayed, press ENTER to confim.
To deactivate Pan inversion, select "Off" and press Enter.
TIL
tion)
1. Press the MENU button until "TIL" is displayed, press ENTER.
Either "On" or "Off" will be displayed.
2. To activate theTilt inversion (counter-clockwise rotation) press the
UP or DOWN buttons until "On" is displayed, press ENTER to confim.
To deactivate tilt inversion, select "Off" and press Enter.
This will let select your desired dimmer curve.
- Pan Inversion (Clockwise or counter-clockwise
- Tilt Inversion (Clockwise or counter-clockwise rota-
ADJ Products, LLC - www.adj.com - XS 400 User Manual Page 11
System Menu