ADJ XS 400 User Instructions page 5

XS 400
Addr
Chnd
StAl
Shnd
Sond
SoSE
LASt
DiND
MENU
PInt
tIL
bAcL
dISP
Nan
Hrs
Uer
rESt
BALA
ADJ Products, LLC - www.adj.com - XS 400 User Manual Page 8
System Menu
A001
Starting DMX address
A512
16CH 16CH=8bit
18CH 18CH=16bit DMX mode
nASt nASt=Master
SLAu=Slave
SLAu
Show0
Internal show, 0-8
Show8
ON
Show to sound
OFF
005 Sound sensitivity, low~High
005-255
255
BLAc=blackout
BLAc
HOLD HOLD=Hold last values
SHOu=Show mode
SHOu
StAn=Standard
StAn
StAG=Stage
StAG
tU tU=TV
ArCH=Architectural
ArCH
tHE tHEA=Theatre
ON On=Counterclockwise
OFF=Clockwise
OFF
OFF=Clockwise
OFF
On=Counterclockwise
ON
on
Display back light
OFF
OFF O =normal
On=reverse
on
CH01
000-255
CH18
Total running hours
Current software version
Vx.x
on
All motors reset
OFF
rED 050-255
GrEN 050-255
White balance adjust
BluE 050-255
UhIt 050-255
XS 400
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
ADDR -
DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is
displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the
UP or DOWN buttons to find your desired address. Press ENTER to
set your desired DMX address.
CHND -
This will let select your desired DMX channel
mode.
1. Press the MENU button until "CHND" is displayed, press ENTER.
The current DMX channel mode will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel
mode and press ENTER to confim and exit.
STAL -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "STAL" is displayed, press ENTER.
Either "MAST" or "SLAv" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
SHND -
Show modes 0-8 (Factory programs).
1. Press the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between
0-8. Shows 1-8 are preset shows, while "Show 0" is random show.
Press the UP or DOWN buttons to find your desired show and press
ADJ Products, LLC - www.adj.com - XS 400 User Manual Page 9
System Menu