Brother 882-D30 Operation Manual page 35

c
Set the supplemental spool pin in the "up"
position.
a Supplemental spool pin
d
Place the spool of thread on the
supplemental spool pin, so that thread
unrolls from the front. Push the spool cap
onto the spool pin as far as possible to
secure the thread spool.
a Spool pin
b Spool cap
c Thread spool
CAUTION
• If the thread spool and/or spool cap are set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
• Use the spool cap (large, medium or small) or
the thread spool insert (mini king thread spool)
that is closest in size to the thread spool. If a
spool cap smaller than the thread spool is
used, the thread may become caught in the slit
on the end of the spool and cause the needle
to break.
Memo
• When using the spool as shown below, use
the thread spool insert (mini king thread
spool).
• Make sure that the thread spool insert is
firmly inserted. After installing it, pull out
some thread, and check that the thread
unwinds without getting caught.
a Thread spool insert (mini king thread spool)
b Hole diameter 8.0mm to 10.5mm (5/16 inch to
13/32 inch)
c Spool (cross-wound thread)
e
With your right hand, hold the thread near
the thread spool. With your left hand, hold
the end of the thread, and use both hands to
pass the thread through the thread guide.
a Thread guide
LOWER THREADING
Basic operations B-33
B
1