Safety Precautions; Compliance Testing - Rimage Prism User Manual

Caution: Indicates that failure to observe this guideline could result in loss or damage to the equipment,
product, software, or data.

Safety Precautions

Warning! Do not disassemble or use tools on the printer. All service procedures should be performed
by an authorized field techni
plugged into the AC outlet.
Caution! All equipment with AC line voltage, or low DC voltages, such as switches, power supplies,
fuses, fans, non-stepper motors, must be replace
safety approval issued by UL.
Caution! Do not reach inside the printer unless absolutely necessary. There may be sharp edges on
some metal parts.
Caution! Do not use the printer if it is overh
fire and an electric shock. In case of heating or abnormal smell, immediately disconnect the cable from
the outlet. Contact your dealer for repairs.
Caution! Do not place or store the printer in a location where children may reach it. Severe injuries and
equipment da mage may occur if the printer is turned over or falls down.
Caution! Allow sufficient free space
moving.

Compliance Testing

Product name: Pris
Model: cdprs
Notice for USA
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provid
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause h
television reception, which can be determined b
user is encouraged to try to correct the interference by one or mo
measures:
•
Reorient or relocate the
• Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This product complies with UL 60950 3
Notice for Canada
110635_I
cian, or sent in for repair. Do not service the printer with the power cord
d with Rimage–approved components to maintain the
eating or an abnormal smell is detected. This may result in a
for opening the printer tray. Do not touch the printer tray while it is
mPlus! Printer
receiving antenna.
armful interference to radio or
y turning the equipment off and on, the
re of the following
rd
Edition.
Learn More
e
19