Rimage Prism User Manual page 21

d. Roll the ribbon leader so that it is wrapped
only once around the roller.
Important! Do not roll past the
marking on the leader that states
STOP - Wind Leader Onto Take-up
Core Stopping here.
e. Install the cardboard take-up roller in the
printer as shown. The ribbon should be
tight and there should be no creases in the
ribbon.
f. Install the take-up roller in the Prism and press down firmly until the take-up roller snaps into place.
Important! Do not roll the STOP - Wind Leader Onto Take-up Core Stopping here marking on the
ribbon leader onto the take-up roller. The marking should not be past the point shown in the
picture above. If the marking is on the roller, pull the take-up roller out and roll back the ribbon. To
take up the slack, roll the supply roller back.
4. To close the tray, press the operator button.
Note: During the ribbon validation process, the ribbon cycles past the ribbon leader. After the ribbon
validation process, ensure that the ribbon is ti
5. Install the top cover. The Prism is ready for use.
110635_I
Maintain the Prism Printer
Ribbon Leader
Marking
ght.
Take-up Roller
17