Advertisement
MOD QW100
The MOD units housing is interchangeable. You can purchase the white housing kit through ADJ.
Changing the housing is very simple process. Follow the instructions below to change the housing.
For more help contact ADJ Customer Support.
1
4
When the screw has been
removed the and safety cable
is disconnected you are able
to remove the innards through
the top of the unit.
MOD QW100
The MOD QW100 comes with 3 interchangeable frost filters. To install the frost filter unscrew the four
thumb screws holding lens in place. Remove the lens and install the filter inside the unit. Line up the
thumb screw holes on the edges of filter with screw holes of the unit. Screw the thumb screws back
into place securing the lens. For help contact ADJ Customer Support.
ADJ Products, LLC - www.adj.com - MOD QW100 User Manual Page 28
2
Start by unscrewing
and removing the
bracket knobs.
5
You are now able to switch
shells by carefully lowering
the innards into the new case
and reassemble. Reconnect the
safety cable and attache the
bracket and knobs.
Housing Change
3
Once the knobs and bracket
have been removed, unscrew
and remove the safety cable
screw.
6
Frost Filter
Advertisement
