Advertisement
MOD QW100
Static Color Mode:
1. Plug the fixture in and press the MODE button until "CLR MACS COLOR: XX" is displayed. "XX"
represents a number between 00-64.
2. Use the UP and DOWN buttons to scroll through the 64 colors and find you desired color. After
you have found your desired color you can activate strobing by pressing the SET UP button to
enter the strobe mode.
3. "STROB: XX" will be displayed, this is strobe mode. The strobing can be adjusted between "00"
(flash off) to "15" (fastest flash).
System Reset:
This will return the fixture to its factory settings.
1. Plug the fixture in and press the MODE button until "OPTION" is displayed.
2. Press the SET UP button until "SYSRESET" is displayed.
3. Press the UP and DOWN buttons simultaneously to reset or press the MODE button to exit.
Dimmer Curve:
This is used to set the dimming curve used with DMX mode. See page 26 for the different dimming
curves.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR: XXX" is displayed.
2. Press the SET UP button until "DELAY: X" is displayed. "X" represents the displayed dimmer
curve (0-4).
•
0 - Standard
•
1 - Stage
•
2 - TV
•
3 - Architectural
•
4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your desired dimming curve.
DMX State:
This mode can be used as a precaution mode, that in case the DMX signal is lost, the operat-
ing mode chosen in the setup is the running mode the fixture will go into when the DMX signal is
lost. You can also set this as the operating mode you would like the unit to return to when power is
applied.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR:XXX" is displayed.
2. Press the SET UP button until "DMX MODE NO" is displayed. The current DMX state will be
displayed.
• "BLACK" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• "HOLD" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX
set up.
• "AUTO" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into
Auto Run mode.
• "MANUA" (Manual) - if the DMX signal is lost or interrupted, the unit will automatically go into the
last color set up in manual dimmer mode.
3. Press the UP or DOWN buttons to scroll through and select your desired DMX state.
ADJ Products, LLC - www.adj.com - MOD QW100 User Manual Page 23
Operating Instructions
Advertisement
