Advertisement
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Check tire pressure in drive tires and pneumatic
casters.
3.
Inflate pneumatic casters to 13 psi (90 kPa).
Inflate drive tires:
• All Models Except Wing Deck Models: 13
psi (90 kPa)
• Wing Deck Models: 18 psi (124 kPa)
4.
Semi-pneumatic caster tires Do Not need to be
inflated.
Note: Do Not add any type of tire liner or foam
fill material to the tires. Excessive loads created by
foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling
tires will void the warranty.
Check Condition Of Belts
Service Interval: Every 50 hours
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Remove left and right belt shields on deck and lift
up floor pan to inspect deck drive belt.
3.
Check under machine to inspect the pump drive
belt.
Note: No adjustments are required for belt
tension.
Lubricate Grease Fittings
Note: See chart for service intervals.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Lubricate fittings with one to two pumps of
NLGI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
All Models Except Wing Deck Models
All Models Except Wing Deck Models (cont'd.)
Lubrication Chart
Fitting
Initial
Locations
Pumps
1
1. Deck and
Pump Idler
Pivots
2. Front
*0
Caster
Pivots
* See step 3 for special lubrication instructions on
the front caster pivots.
Wing Deck Models
Lubrication Chart
Fitting
Initial
Locations
Pumps
1
1. Deck and
Pump Idler
Pivots
2. Caster
*0
Pivots
3. Front
*0
Caster
Wheel
Bearings
65
Maintenance
Number of
Service
Places
Interval
2
Yearly
2
*Yearly
Number of
Service
Places
Interval
4
Yearly
5
*Yearly
4
*Yearly
Advertisement
