Advertisement
Specifications
E-Series: (cont'd.)
Front Caster
Semi-Pneumatic
Deck Size
"A1" and
"C1"
Models
Quantity
2
Smooth
Tread
Size
13 x 6.50-6
Ply Rating
Pressure
Cutting Deck
• Cutting Width:
– 48 inch Deck: (121.9 cm)
– 52 inch Deck: (132.1 cm)
– 60 inch Deck: (152.4 cm)
– 72 inch Deck: (182.9 cm)
– 96 inch Deck: (243.8 cm)
• Discharge:
– Side Discharge: Non "R" models
– Rear Discharge: "R" models
• Blade Size: (3 ea.)
– 48 inch Deck: 16.25 inches (41.3 cm)
– 52 inch Deck: 18.00 inches (45.7 cm)
– 60 inch Deck: 20.50 inches (52.1 cm)
– 72 inch Deck: 24.50 inches (62.2 cm)
– 96 inch Deck: 24.50 inches (62.2 cm)
• Blade Spindles:
– X-Series-All except 96 inch Deck: Solid steel
spindles with 1.18 inch (30 mm) I.D. bearings.
– X-Series-96 inch Deck: Solid steel spindles
with .984 inch (25 mm) I.D. bearings.
– S and E-Series: Solid steel spindles with .984
inch (25 mm) I.D. bearings.
• Deck Drive:
Electric clutch:
Pneumatic
(Air filled)
"A2"
"A3"
and "00"
Models
Models
2
2
Smooth
Smooth
13 x 5.00-6
13 x 6.50-12
4
13 psi
(90 kPa)
– 48 and 52 inch, 60R, 72R Decks: "B" Section
belt with self-tensioning idler.
– 60 and 72 inch Decks: 5V Section belt with
self-tensioning idler.
– 96 Inch Deck: One 5V belt on center deck.
One "A" Section belt on each wing.
• Deck:
– Side Discharge: Full floating deck is attached
to out-front support frame. Anti-scalp rollers
provide maximum turf protection. Deck
design allows for bagging, mulching or side
discharge.
◊ 48 inch Deck: 3 anti-scalp rollers
◊ 52 inch Deck: 3 anti-scalp rollers
◊ 60 inch Deck: 4 anti-scalp rollers
◊ 72 inch Deck: 6 anti-scalp rollers
– Rear Discharge: Full floating deck is attached
to out-front support frame. Anti-scalp rollers
and side bumpers provide maximum turf
protection. Deck design allows for rear
discharge or finish cut (reduced discharge).
◊ 60 inch Deck: 4 anti-scalp rollers
◊ 72 inch Deck: 4 anti-scalp rollers
◊ 96 Inch Deck: 13 anti-scalp rollers
• Deck Depth—All Deck Series: 5.5 inches (14 cm)
• Cutting Height Adjustment:
– For Non-Wing Deck Models: Foot activated
lever is used to adjust the cutting height from
1 inch (2.5 cm) to 5 1/2 inches (14 cm) in 1/4
inch (6.4 mm) increments.
– For Wing Deck Models: Pressing the deck lift
switch causes a hydraulic cylinder to raise or
lower the deck and side wings.
• Mulching Kit: Optional.
22
Advertisement
