Fisher & Paykel DD601 Service Manual page 21

4.4 Diagnostics Quick Reference Flow Chart cont'd
Press Power
Button
#4 Continuous Cycle Test Mode
Once a mode has been entered, press Power to exit diagnostics
except Display and Show Off modes) which require the plug to be removed from the power socket.
Rinse Aid Adjustments/Tub Open Beep/Water Pressure Setup
LCD Display on. Hold
the Programme and
Eco Touch Switches
simultaneously for
5 seconds
Water Pressure option
is available if water
pressure is below
50kPa and a 'U1'fault
occurs during wash
cycles. If this happens
then change water
pressure setting to 'LP'.
(Factory setting is 'HP'.)
Press
Start/Pause
button
Press Key Lock.
Press Key Lock
Press
Start/Pause
Press
Start/Pause
Continuous
cycle
Red Red
Select desired cycle and
Continuous cycle is indicated
Stand - by
by backlight alternating
mode
between green & orange. In
this mode the cycle count is
Machine Beeps
and "HP" is
displayed in
the LCD.
This turns the
Smiley Face off &
deactivates Tub
Open
beeps.
This turns the
Smiley Face on &
activates Tub
Open
beeps.
This adjusts
water pressure
set up from high
to low.
This adjusts
water pressure
set up from
low to high
- 21 -
LCD is Rd backlight
and displays CC.
Touchswitch panel is
Red Red
operate as normal.
displayed.
Push Wash
Programme Selection
Touch Switch to select
dose of Rinse Aid.
Each LED = 1cc.
Press Power to Exit.
Press Power to
exit