Hyundai 30EPER Operator's Manual page 47

15.2.9 Make sure that all the nameplates, indicator boards and labels (pattern) are clear and legible.
15.2.10 Inspection shall be taken for fuel oil system and auxiliary fittings to see if there is any leakage. Soap
bath shall be used for leakage inspection of liquefied petroleum gas system. Truck must leave the
working site in case of any leakage in fuel oil system. And the truck cannot be put into operation
until all the leakages have been repaired.
Inspection must be taken before reuse of all the dismountable liquefied petroleum gas containers
or filling fuel into all the liquefied petroleum gas containers, to see whether there is the following
defective or damage:
A Dent, scuffing, flute;
）
B Damage of various valves or lever meters;
）
C Scraps in emergency valve;
）
D Damage or loss of emergency valve bonnet;
）
E Leakage at connection of valve and thread;
）
F Deterioration, damage, or loss of flexible seal at connections of gas filling or gas supply.
）
In case of occurrence of any defective or damage as above mentioned, no container would
be allowed to be used before repair.
15.2.11 Neither modification in design nor addition to the truck shall be taken without permission of the
manufacture for sake of weakening performance or operation security of the truck. Nameplate and
instruction manual shall be revised accordingly in that condition.
15.2.12 Special purpose truck or equipment that is designed for dangerous condition, or is permitted to be
used under dangerous condition, shall be paid special attention to, thus ensure the original safe
operation performance of the truck.
15.2.13 All the components that are used for replacement must be of the same model, or at least of the
same quality with the original part.
15.2.14 Industrial truck must be kept clean for sake of fire. Find loose or defective part in time. Keep clean
for lifting device, carrying device, wheel tread, foot pedal, and floor of the truck. No grease, oil
stain, or other dirty substances shall be kept.
15.3 Inspection
15.3.1 If any potential defective, abrasion, or damage is found in the vehicle after inspection, which would
threaten safe performance, effective measure shall be taken. Truck cannot be put into operation
before repair.
15.3.2 Protective maintenance, lubrication and inspection shall be taken in accordance with schedule for
the truck. Data that are in demand of record shall be carefully kept.
44