Ⅸ. The Store And Transportation Of Forklift; Ⅹ. The Tow Of The Pallet Truck - Hyundai 30EPER Operator's Manual

Ⅸ. The store, transportation and loading of truck:
1 The store of truck:
If the electric pallet truck is not used for over two months, it should be placed in the room which is in
good ventilation, no frost, clean and dry; also the following measures should be taken:
Clean the truck thoroughly.
Lift the forks completely for several times, check if it is normal or not.
Lower the forks to the lowest position.
Support the side near driver of truck with square timber to lift the driving wheels of truck from the
ground.
Apply a layer of flimsy oil or grease on all the bared surface of mechanical parts.
Lubricate the truck.
Check the status of storage battery and electrolyte, and imbrue the non-acid lubricating grease to the
binding post of storage battery.
All the electrical contacts should be sprayed using appropriate contacts spray.
2 Transportation of truck:
If the truck needs to be transported for a long distance, support the side near to driver of truck with
square timber to lift the driving wheels of truck from the ground. The two front wheels of truck shall
be fixed stably by sphenoid wood block. Fasten the truck to transport vehicle with ropes.
3 Loading and unloading of truck:
Before loading the truck, check out the nameplate for the total weight of truck to choose appropriate
hoisting handling equipment. The hoisting of truck shall be kept level, and landing shall be kept slow
and stable. The personnel around shall watch for safety. One of the personnel is responsible for
conducting. If the other truck is used for loading and unloading, please watch the bottom situation of
the truck. Take care to insert the fork arms to the bottom, in avoidance of damaging the driving wheel,
balance wheel and forward wheel.
Ⅹ. Replacement of storage battery
The weight of battery pack is about 290kg, and the replacement procedure of storage battery is as follows:
1. Pull down the socket connector of storage battery from the truck.
2. Turn on the
safety pin of battery pack
3. Pull out the storage battery from the side way and take the storage battery away with special car or using
hoisting method.
4. The mounting method of putting the storage battery back into the battery pack is opposite to the above
procedures.
Note
Handle the storage battery gently during hoisting and transportation of the battery. Otherwise it will cause damage to
the battery or bring danger to human body.
25