Hyundai 30EPER Operator's Manual page 40

The driving type high –lift truck should be mounted with protection cabane, except for the
condition where the load could not drop onto the driver.
When convey the load maybe fall to the driver using high –lift truck, should adopt shielding shelf
with enough height, weight and the opening size is small enough to prevent the entire load or
part of them from falling onto the driver.
When it is necessary to denote the working condition, the truck should add caution device, such
as light or flash lamp.
In the permit of the factory, it is allowed to install turning hand hold on the steering wheel
formerly without it.
14.1.4.4 The transportation and storage of the fuel
The truck should refuel in the stated place. The fuel station should be ventilative, in order to
reduce the accumulation of the fuel gas to the least. In opening pit, subway entrance, and lift well
or other similar conditions nearby should not fill in the liquefied petroleum gas and replace other
dismountable liquefied petroleum gas container.
It is forbidden to smoke in the place of refuel, and should alarm using placard.
If the liquid fuel is not transport using pipeline, it should be transported using airtight container.
Only the personnel trained and appointed can fill or change the liquefied petroleum gas
container.
When store and transport the liquefied petroleum gas container, should fasten up the filling valve,
and the safety valve should connected to the vaporization room directly. When storing the
container, should screw the protective cap on the connection mouth.
Before filling and/or reusing, should inspect the container to ensure that it is vapor proof.
Especially pay attention to the valve and the connective part is vapor proof. The damaged
container should not be used. Only the permitted corporation could repair the liquefied
petroleum gas container.
14.1.4.5 The charging and changing of the battery
The battery charging station should set in the appointed area. The charging station should
prepare the equipment using for flushing and neutralizing the overflow electrolyte, the fire
control device, the measure avoiding the truck damage the charging device and the adequacy
ventilation facility blow away the fume off from the battery.
In the area of charging, it is forbidden to smoke and alarm with placard.
Only the personnel trained and permitted can change or charge the battery. The battery
repairing people should wear protective clothes.
All the work of changing the battery should carried out according to the description of user's
manual from the factory. When reinstall the battery, should adopt measures to make the battery
connecting, orientation and fixation correctly. Do not put tools and other metal substance on the
lidless battery.
Without the special approval (for example the truck factory), the electrical motor truck should
not change the battery with different voltage, weight or size.
It is obliged to use the battery stated by the factory. It is obliged to prepare the facility for
changing battery safely. When hanging up the battery using hoisting equipment, it is necessary
to use insulated steeve.
If adopting chain hoist, it is necessary to equip chain box. If adopting chain block, the lidless
battery should be covered by a piece of rubber blanket or other insulated materials, to prevent
the short circuit of chain and the connecting wire or connecting terminal between the battery
lattices.
14.1.4.6 The invalid or damaged truck
If finding the motor industrial vehicle existing insecurity factors, it should stop using and give
away on the spot. After repairing and recovery to the safety conditions, it can be reused.
14.1.4.7 Accident
Once the accident happens, for example the staff injures, the truck damages the building or the
equipment, firstly should organize salvage, do best to protect the accident field and report to the
governor.
14.1.5 Operating conditions
14.1.5.1 Channel and stacking field
The ground of the operating field should have enough carrying capacity, and it is necessary to
maintain it well not to influence the truck operating safely.
The transporting channel of the truck should have well visual field, and it is easy to turn, and no
37