Table of Contents
Advertisement
away from the elevator (lifter).
After the bridge box floor of the elevator (lifter) is even to the ground, the truck should slowly
drive in as the positive direction.
It should be the load go into the elevator (lifter) first not the driver, this is specially adapted to the
walking type truck.
After the truck driving into the elevator (lifter), it is necessary to put the control device in the
central position. Switch off the power, and tighten the brake.
14.2.3.8 Parking
After the driver leaving, the carrying device must lower to the lowest position, put the control
device to the central position, switch off the power, and tighten the brake, stay steady the
vehicle to prevent accidental move or make bold by others without approval.
When parking the truck, the fire fighting passage, access stairs and fire fighting passages should
keep fluently.
The parking location of the truck should keep a safety distance to the railway.
14.2.4
The vehicle maintaining rule for the drivers
14.2.4.1 General rule
Before starting the truck, it is necessary to inspect the technical condition of the truck. According
to the different type of the truck, should pay more attention to some special location: [for
example: fuel oil system, alarm system, power system, brake, steering equipment, lighting, wheel
and air tire pressure (namely gas filled type) and lifting system (including lifting chain, wire rope,
limit switch and hydraulic cylinder).
If the truck is found to be repaired, or during the operation the defect develops, it is necessary
to report it to the superior in concern. It is forbidden to repair or adjust the truck by the truck by
the driver without permission.
The truck which fuel oil system is leaking could not be uses without repair.
14.2.4.2 Refuel
Before refuel, it is necessary to close the engine, brake the truck and the driver should leave the
truck.
The open flame and smoking is forbidden during refueling.
14.2.4.2.1
Liquid fuel (for example gasoline and diesel fuel)
The truck using liquid fuel should add fuel in the appointed places.
Before take away the refueling equipment, cover the filler cap and clear up the excessive fuel,
the engine could not start up.
14.2.4.2.2
Liquefied petroleum gas fuel (liquefied petroleum gas)
Only the personnel trained and appointed can refuel or change the liquefied petroleum gas
container.
The person charging for refuel liquefied petroleum gas should wear protective suit (that is to
say long sleeve unit and glove).
The pouring of the fixed type liquefied petroleum gas container and the pouring and change
of the liquefied petroleum gas container should be carried on the appointed place.
When transporting or conveying the liquefied petroleum gas container, it is necessary to be
careful, the container should not fall down, nor be thrown, rolling or draw. If it is necessary to
transport several containers one time, a proper transporting device should be adopted.
The liquefied petroleum gas container should not be filled in excessive.
Before filling the fuel, power off the engine, brake the truck, and the driver leave away the
truck.
It is necessary to using soap liquid to check the leak dictation.
The truck driven by liquefied petroleum gas could not park near the heat source, open flame
or the similar ignition, and not near to the open air pit, the entrance of the under crossing, the
elevator well or other similar place, and could not change the removable container in the upper
place.
Before fill fuel into all liquefied petroleum gas container and before the reuse of the removable
liquefied petroleum gas container, it is necessary to inspect if there is defect or damage as
follows:
A
the dent, scoring and groove of the pressure container;
）
B
the damage of any kinds of valve and fluid level gage;
）
C
the scraping in the safety valve;
）
D
the damage or the lose of the safety bonnet;
）
42
Advertisement
Table of Contents
