Table of Contents
Advertisement
storage battery by the professional personnel before the first use. First, place the truck to the site with
good ventilation, open the lid of storage battery box, and open all the top plastic lids of storage battery.
The plastic pot with storage battery electrolyte inside is raised using plastic funnel, and the electrolyte is
poured into the storage battery in a slow way until the liquid level can be seen. After all the storage battery
is filled, conduct initial charge to the storage battery timely according to the operation requirements of
initial charge 5.1.
3 Daily inspection
Inspection of hydraulic oil level: lower the fork to the lowest position, look over the oil level from the oil
window. The distance between oil level and the bottom of oil tank is about 70mm, and oil charge is 1.5L.
Recommendatory trademark for the hydraulic oil should be chosen.
Check the capacity of storage battery: refer to the use and maintenance of storage battery.
4 The inspection according to the need
Clean the truck
Inspect and screw down each fastener
Inspect the damage state of wheels
5 The inspection and maintenance after 50 hours （Weekly）
Braking
system
Capacity of
electrolyte
Capability of
electrolyte
Clean
the
storage
battery
Inspect the
contactor
20
When the operation handle is turned, with the steering handle switching
1
between area A and B, there is a noise from the brake.
2
The oil dirt and dust on the turning gearwheel should be cleaned.
3
The clearance between brakes should be kept between 0.2mm and 0.8mm
Inspect the liquid level of electrolyte, pure water can be used for
4
supplement if the liquid level is too low.
5
The specific gravity should be1.28g/ml after charged.
6
Cover the lid, and flush with tap water.
7
Burnish the coarse surface of contacts using sand paper.
Advertisement
Table of Contents
